Search

Search Results

• 1. [Image] Atlantic coastal plain geothermal test holes, New Jersey: Hole completion reports

  	A description of the Atlantic Coastal Plains Geothermal Drilling Program and data for the following Geothermal test holes drilled in New Jersey are summarized: Site No. 40, Fort Monmouth; Site No. 41, ...
  	Citation × Citation Citation Abstract Copy Title: Atlantic coastal plain geothermal test holes, New Jersey: Hole completion reports Author: Cobb, L.B. Year: 1979 A description of the Atlantic Coastal Plains Geothermal Drilling Program and data for the following Geothermal test holes drilled in New Jersey are summarized: Site No. 40, Fort Monmouth; Site No. 41, Sea Girt; Site No. 39-A, Forked River; Site No. 38, Atlantic City; and Site No. 36, Cape May; NVO-1558-1 Title: Atlantic coastal plain geothermal test holes, New Jersey: Hole completion reports Author: Cobb, L.B. Year: 1979 A description of the Atlantic Coastal Plains Geothermal Drilling Program and data for the following Geothermal test holes drilled in New Jersey are summarized: Site No. 40, Fort Monmouth; Site No. 41, Sea Girt; Site No. 39-A, Forked River; Site No. 38, Atlantic City; and Site No. 36, Cape May; NVO-1558-1 Close

• 2. [Image] Investigations of the Dunes Geothermal Anomaly, Imperial Valley, California: Part 1. Geochemistry of Geothermal Fluid

  	A geothermal test borehole, DWR Dunes No. 1, was drilled in the Dunes geothermal anomaly by the State of California Department of Water Resources. Water samples from this geothermal system were collected ...
  	Citation × Citation Citation Abstract Copy Title: Investigations of the Dunes Geothermal Anomaly, Imperial Valley, California: Part 1. Geochemistry of Geothermal Fluid Author: Coplen, T.B. Year: 1974 A geothermal test borehole, DWR Dunes No. 1, was drilled in the Dunes geothermal anomaly by the State of California Department of Water Resources. Water samples from this geothermal system were collected from perforations at 109 and 260 meters depth. These water samples were analyzed for chemical and isotopic composition. These tests indicate that the source of the geothermal fluid is partially evaporated Colorado River water. An investigation of chloride/bromide ratios was used to determine the source of the salt in the geothermal fluid from Dunes. The result may suggest that the salt in the Salton Sea geothermal system and in the Dunes geothermal anomaly is derived from the Colorado River and that this water has not done any leaching or been mixed with water from other sources. It was determined that further geophysical Studies (gravity, seismic refraction, electrical resistivity, and magnetotelluric sounding) are needed to locate the reservoir of geothermal fluid in the Dunes system Title: Investigations of the Dunes Geothermal Anomaly, Imperial Valley, California: Part 1. Geochemistry of Geothermal Fluid Author: Coplen, T.B. Year: 1974 A geothermal test borehole, DWR Dunes No. 1, was drilled in the Dunes geothermal anomaly by the State of California Department of Water Resources. Water samples from this geothermal system were collected from perforations at 109 and 260 meters depth. These water samples were analyzed for chemical and isotopic composition. These tests indicate that the source of the geothermal fluid is partially evaporated Colorado River water. An investigation of chloride/bromide ratios was used to determine the source of the salt in the geothermal fluid from Dunes. The result may suggest that the salt in the Salton Sea geothermal system and in the Dunes geothermal anomaly is derived from the Colorado River and that this water has not done any leaching or been mixed with water from other sources. It was determined that further geophysical Studies (gravity, seismic refraction, electrical resistivity, and magnetotelluric sounding) are needed to locate the reservoir of geothermal fluid in the Dunes system Close

• 3. [Image] Investigation and evaluation of geopressured-geothermal wells. Fairfax Foster Sutter No. 2 well, St. Mary Parish, Louisiana. Volume I. Completion and testing. Final report

  	The Fairfax Foster Sutter No. 2 well, located in the East Franklin area of St. Mary Parish, Louisiana, is the first successful test of a geopressured-geothermal aquifer under the Well-of-Opportunity program. ...
  	Citation × Citation Citation Abstract Copy Title: Investigation and evaluation of geopressured-geothermal wells. Fairfax Foster Sutter No. 2 well, St. Mary Parish, Louisiana. Volume I. Completion and testing. Final report Author: Willits, M.H. Year: 1979 The Fairfax Foster Sutter No. 2 well, located in the East Franklin area of St. Mary Parish, Louisiana, is the first successful test of a geopressured-geothermal aquifer under the Well-of-Opportunity program. The section tested was the MA-6 sand of lower Miocene age which has produced large quantities of gas from the adjacent but structurally separated Garden City field. In the subject well the observed temperature was 270{sup 0}F (132{sup 0}C) and the measured gradient was 0.77 psi/ft. The gross sand thickness was 270 feet, the net sand thickness 190 feet, and the tested interval 58 net feet. The temperatures and pressures encountered approached the limits of the surface-recording bottomhole pressure gauge and particularly the single-conductor cables on which the gauges were run. The objectives of the tests were all accomplished, and data were obtained which will contribute to the overall assessment of the geopressured-geothermal resource of the Upper Gulf of Mexico basin. In general, the gas solubility (22.8 scf/bbl) was as expected for the temperature, pressure, and salinity of the brine. The produced water was more saline than expected (160,000 mg/l). The high concentrations of dissolved solids, coupled with the evolution of CO{sub 2} from these waters during production, created a scaling problem in the tubular goods and surface equipment that will have to be addressed in future tests; DOE/ET/28460-1 Title: Investigation and evaluation of geopressured-geothermal wells. Fairfax Foster Sutter No. 2 well, St. Mary Parish, Louisiana. Volume I. Completion and testing. Final report Author: Willits, M.H. Year: 1979 The Fairfax Foster Sutter No. 2 well, located in the East Franklin area of St. Mary Parish, Louisiana, is the first successful test of a geopressured-geothermal aquifer under the Well-of-Opportunity program. The section tested was the MA-6 sand of lower Miocene age which has produced large quantities of gas from the adjacent but structurally separated Garden City field. In the subject well the observed temperature was 270{sup 0}F (132{sup 0}C) and the measured gradient was 0.77 psi/ft. The gross sand thickness was 270 feet, the net sand thickness 190 feet, and the tested interval 58 net feet. The temperatures and pressures encountered approached the limits of the surface-recording bottomhole pressure gauge and particularly the single-conductor cables on which the gauges were run. The objectives of the tests were all accomplished, and data were obtained which will contribute to the overall assessment of the geopressured-geothermal resource of the Upper Gulf of Mexico basin. In general, the gas solubility (22.8 scf/bbl) was as expected for the temperature, pressure, and salinity of the brine. The produced water was more saline than expected (160,000 mg/l). The high concentrations of dissolved solids, coupled with the evolution of CO{sub 2} from these waters during production, created a scaling problem in the tubular goods and surface equipment that will have to be addressed in future tests; DOE/ET/28460-1 Close

• 4. [Image] Geothermal direct heat project, Marlin, Texas: Environmental assessment

  	The Federal action addressed is retrofitting a heating and hot water system in a hospital at Marlin, Texas, with a geothermal preheat system. The project will be located within the existing hospital boiler ...
  	Citation × Citation Citation Abstract Copy Title: Geothermal direct heat project, Marlin, Texas: Environmental assessment Year: 1979 The Federal action addressed is retrofitting a heating and hot water system in a hospital at Marlin, Texas, with a geothermal preheat system. The project will be located within the existing hospital boiler room. One supply well will be drilled in an existing adjacent parking lot. Fluid disposal from operation will depend on fluid properties and may be by surface disposal to existing street drains, by surface disposal to a new drainage system, or by injection into a new injection well, depending on total dissolved solids (TDS) content. Environmental impacts of construction are expected to be small because of the existing structures and paved areas. Construction run-off and geothermal flow-test fluid will pass through a small pond in the city park, lowering its water quality, at least temporarily. Construction noise is not expected to be out of character with existing noises around the hospital. Project operation is not expected to produce significant impacts because of the decision point to determine fluid composition prior to designating a disposal method. Injection would be into a saline aquifer, and surface discharge would not appreciably lower water quality in the Brazos River; DOE/EA-0067 Title: Geothermal direct heat project, Marlin, Texas: Environmental assessment Year: 1979 The Federal action addressed is retrofitting a heating and hot water system in a hospital at Marlin, Texas, with a geothermal preheat system. The project will be located within the existing hospital boiler room. One supply well will be drilled in an existing adjacent parking lot. Fluid disposal from operation will depend on fluid properties and may be by surface disposal to existing street drains, by surface disposal to a new drainage system, or by injection into a new injection well, depending on total dissolved solids (TDS) content. Environmental impacts of construction are expected to be small because of the existing structures and paved areas. Construction run-off and geothermal flow-test fluid will pass through a small pond in the city park, lowering its water quality, at least temporarily. Construction noise is not expected to be out of character with existing noises around the hospital. Project operation is not expected to produce significant impacts because of the decision point to determine fluid composition prior to designating a disposal method. Injection would be into a saline aquifer, and surface discharge would not appreciably lower water quality in the Brazos River; DOE/EA-0067 Close

• 5. [Image] DHE (Downhole Heat Exchangers)

  	The use of downhole heat exchangers (DHE) for residential or commercial space and domestic water heating and other applications has several desirable features. Systems are nearly or completely passive ...
  	Citation × Citation Citation Abstract Copy Title: DHE (Downhole Heat Exchangers) Author: Culver, G. Year: 1990 The use of downhole heat exchangers (DHE) for residential or commercial space and domestic water heating and other applications has several desirable features. Systems are nearly or completely passive -- that is, no or very little geothermal water or steam is produced from the well either reducing or completely eliminating surface environmental concerns and the need for disposal systems or injection wells. Initial cost of pumps and installation are eliminated or reduced along with pumping power costs and maintenance costs associated with pumping often corrosive geothermal fluids. Many residential and small commercial systems do not require circulating pumps because the density difference in the incoming and outgoing sides of the loop are sufficient to overcome circulating friction losses in the entire system. The major disadvantage of DHEs is their dependence on natural heat flow. In areas where geological conditions provide high permeability and a natural hydraulic gradient, DHEs can provide a substantial quantity of heat. A single 500-ft (152 m) well in Klamath Falls, Oregon, supplies over one megawatt thermal and output is apparently limited by the surface area of pipe that can be installed in the well bore. In contrast, DHEs used in conjunction with heat pumps may supply less than 8 KW from a well of similar depth. Here output is limited by conductive heat flow with perhaps a small contribution from convection near the well bore. The highest capacity DHE reported to date, in Turkey, supplies 6 MW thermal from an 820-ft (250 m) well. There were two main goals for this project. The first was to gather, disseminate and exchange internationally information on DHEs. The second was to perform experiments that would provide insight into well bore/aquifer interaction and thereby provide more information on which to base DHE designs. 27 refs., 31 figs., 3 tabs. Title: DHE (Downhole Heat Exchangers) Author: Culver, G. Year: 1990 The use of downhole heat exchangers (DHE) for residential or commercial space and domestic water heating and other applications has several desirable features. Systems are nearly or completely passive -- that is, no or very little geothermal water or steam is produced from the well either reducing or completely eliminating surface environmental concerns and the need for disposal systems or injection wells. Initial cost of pumps and installation are eliminated or reduced along with pumping power costs and maintenance costs associated with pumping often corrosive geothermal fluids. Many residential and small commercial systems do not require circulating pumps because the density difference in the incoming and outgoing sides of the loop are sufficient to overcome circulating friction losses in the entire system. The major disadvantage of DHEs is their dependence on natural heat flow. In areas where geological conditions provide high permeability and a natural hydraulic gradient, DHEs can provide a substantial quantity of heat. A single 500-ft (152 m) well in Klamath Falls, Oregon, supplies over one megawatt thermal and output is apparently limited by the surface area of pipe that can be installed in the well bore. In contrast, DHEs used in conjunction with heat pumps may supply less than 8 KW from a well of similar depth. Here output is limited by conductive heat flow with perhaps a small contribution from convection near the well bore. The highest capacity DHE reported to date, in Turkey, supplies 6 MW thermal from an 820-ft (250 m) well. There were two main goals for this project. The first was to gather, disseminate and exchange internationally information on DHEs. The second was to perform experiments that would provide insight into well bore/aquifer interaction and thereby provide more information on which to base DHE designs. 27 refs., 31 figs., 3 tabs. Close