Search

Search Results

• 1. [Article] Improving the Representation of the Pedestrian Environment in Travel Demand Models, Phase I

  There is growing support for improvements to the quality of the walking environment, including more investments to promote pedestrian travel. Metropolitan planning organizations (MPOs) are improving regional ...

  Citation × Citation Citation Abstract Copy Title: Improving the Representation of the Pedestrian Environment in Travel Demand Models, Phase I Author: Clifton, Kelly J., Singleton, Patrick Allen, Muhs, Christopher Devlin, Schneider, Robert J., Lagerwey, Peter Year: 2013 There is growing support for improvements to the quality of the walking environment, including more investments to promote pedestrian travel. Metropolitan planning organizations (MPOs) are improving regional travel demand forecasting models to better represent walking and bicycling and to expand the evaluative capacity of models to address policy-relevant issues like air quality, public health, and the smart allocation of infrastructure and other resources. This report describes an innovative, spatially disaggregate method to integrate walking activity into trip-based travel models. Using data for the Portland, OR, metropolitan area, the method applies trip generation at a new micro-scale spatial unit: a 264-foot-by-264-foot (80-meters-by-80-meters) pedestrian analysis zone (PAZ). Next, a binary logit walk mode split model — using a new pedestrian environment measure — estimates the number of walk trips generated. Non-walk trips are then aggregated up to larger transportation analysis zones (TAZs) for destination choice, mode choice, and traffic assignment. Finally, there are opportunities for choosing destinations and for routing of the PAZ pedestrian trips. This method improves travel models’ sensitivity to policy-and investment-related walking influences, and it could operate as a standalone tool for rapid scenario analysis. Care must be taken when applying this method with respect to scalability, forecasting, and operational challenges. Title: Improving the Representation of the Pedestrian Environment in Travel Demand Models, Phase I Author: Clifton, Kelly J., Singleton, Patrick Allen, Muhs, Christopher Devlin, Schneider, Robert J., Lagerwey, Peter Year: 2013 There is growing support for improvements to the quality of the walking environment, including more investments to promote pedestrian travel. Metropolitan planning organizations (MPOs) are improving regional travel demand forecasting models to better represent walking and bicycling and to expand the evaluative capacity of models to address policy-relevant issues like air quality, public health, and the smart allocation of infrastructure and other resources. This report describes an innovative, spatially disaggregate method to integrate walking activity into trip-based travel models. Using data for the Portland, OR, metropolitan area, the method applies trip generation at a new micro-scale spatial unit: a 264-foot-by-264-foot (80-meters-by-80-meters) pedestrian analysis zone (PAZ). Next, a binary logit walk mode split model — using a new pedestrian environment measure — estimates the number of walk trips generated. Non-walk trips are then aggregated up to larger transportation analysis zones (TAZs) for destination choice, mode choice, and traffic assignment. Finally, there are opportunities for choosing destinations and for routing of the PAZ pedestrian trips. This method improves travel models’ sensitivity to policy-and investment-related walking influences, and it could operate as a standalone tool for rapid scenario analysis. Care must be taken when applying this method with respect to scalability, forecasting, and operational challenges. Close

• 2. [Article] Contextual Influences on Trip Generation

  There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE ...

  Citation × Citation Citation Abstract Copy Title: Contextual Influences on Trip Generation Author: Clifton, Kelly J., Currans, Kristina Marie, Muhs, Christopher D. Year: 2012 There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE rates represent travel behavior for development in single lots and uses, primarily measured in low-density suburban areas. Despite evidence that a more compact urban form, access to transit and a greater mix of uses generates fewer and shorter vehicle trips, local governments are often compelled to use current ITE trip generation rates to evaluate transportation impacts and calculate transportation system development charges (TSDCs). This is due to: a) the expense of collecting local data, b) lack of alternative sources of information, c) the strong industry bias toward using ITE published rates and d) the absence of a empirically tested methodology for adjusting those rates for development occurring in different land use and transportation contexts. Compounding these challenges, cities in Oregon are required to demonstrate that planning and zoning changes will not degrade the performance of state-owned transportation facilities compared to the levels of service documented in the Regional Transportation Plan under the Oregon Transportation Planning Rule, section -0060, and Oregon Highway Plan, Policy 1.F.6. These requirements can conflict with regional policies in Metro's 2040 Growth Concept that call for development of mixed-use centers and corridors to support jobs and freight reliability, a compact urban form and leverage transportation investments such as high capacity transit. Thus, there are gaps in the understanding about how best to evaluate, mitigate and plan for growth under these conditions. This research proposes to develop multi-modal trip generation rates that better reflect the relationship between land use, transportation and travel demand for specific land use types located in various urban settings. The project aims to collect local data (using multi-modal counts and establishment surveys) on a few specific land uses (deemed most problematic to estimate demand and occurring across the spectrum of urban conditions) to develop trip generation rates that are sensitive to demographic, land use and transportation contexts. These new trip rates will be compared to the ITE rates for the same land use category and a methodology for adjusting the ITE rates will be developed. This adjustment methodology will be validated, using additional data collected in this research. The research will be documented and made available to local partners and disseminated widely to reach out to other communities across the country. The research conducted for this project would account for how the built environment (e.g., both land use and transportation) influences travel behavior (number of trips, trip length, mode choice), and determine trip rates that reflect the entire activity spectrum of different development/place typologies. This is extremely important in determining the impact of different development types on the transportation system to: 1) avoid over-planning the system for the surrounding land uses; (2) suggest strategies and investment priorities to encourage more compact, mixed-use areas with more transportation choices and 3) avoid creating regulatory and/or financial barriers to compact form envisioned by local, regional and statewide plans (i.e. uniform TSDCs can result in lower impact development paying the same rates, and thus subsidizing development with higher impact costs to the transportation system). The documentation of the findings and methodology will be applicable to current and future growth and be transferable to other communities, locally and nationally, beyond the Portland region. Title: Contextual Influences on Trip Generation Author: Clifton, Kelly J., Currans, Kristina Marie, Muhs, Christopher D. Year: 2012 There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE rates represent travel behavior for development in single lots and uses, primarily measured in low-density suburban areas. Despite evidence that a more compact urban form, access to transit and a greater mix of uses generates fewer and shorter vehicle trips, local governments are often compelled to use current ITE trip generation rates to evaluate transportation impacts and calculate transportation system development charges (TSDCs). This is due to: a) the expense of collecting local data, b) lack of alternative sources of information, c) the strong industry bias toward using ITE published rates and d) the absence of a empirically tested methodology for adjusting those rates for development occurring in different land use and transportation contexts. Compounding these challenges, cities in Oregon are required to demonstrate that planning and zoning changes will not degrade the performance of state-owned transportation facilities compared to the levels of service documented in the Regional Transportation Plan under the Oregon Transportation Planning Rule, section -0060, and Oregon Highway Plan, Policy 1.F.6. These requirements can conflict with regional policies in Metro's 2040 Growth Concept that call for development of mixed-use centers and corridors to support jobs and freight reliability, a compact urban form and leverage transportation investments such as high capacity transit. Thus, there are gaps in the understanding about how best to evaluate, mitigate and plan for growth under these conditions. This research proposes to develop multi-modal trip generation rates that better reflect the relationship between land use, transportation and travel demand for specific land use types located in various urban settings. The project aims to collect local data (using multi-modal counts and establishment surveys) on a few specific land uses (deemed most problematic to estimate demand and occurring across the spectrum of urban conditions) to develop trip generation rates that are sensitive to demographic, land use and transportation contexts. These new trip rates will be compared to the ITE rates for the same land use category and a methodology for adjusting the ITE rates will be developed. This adjustment methodology will be validated, using additional data collected in this research. The research will be documented and made available to local partners and disseminated widely to reach out to other communities across the country. The research conducted for this project would account for how the built environment (e.g., both land use and transportation) influences travel behavior (number of trips, trip length, mode choice), and determine trip rates that reflect the entire activity spectrum of different development/place typologies. This is extremely important in determining the impact of different development types on the transportation system to: 1) avoid over-planning the system for the surrounding land uses; (2) suggest strategies and investment priorities to encourage more compact, mixed-use areas with more transportation choices and 3) avoid creating regulatory and/or financial barriers to compact form envisioned by local, regional and statewide plans (i.e. uniform TSDCs can result in lower impact development paying the same rates, and thus subsidizing development with higher impact costs to the transportation system). The documentation of the findings and methodology will be applicable to current and future growth and be transferable to other communities, locally and nationally, beyond the Portland region. Close