Search

Search Results

• 31. [Article] Exploring Pedestrian Responsive Traffic Signal Timing Strategies in Urban Areas

  The role of walking in the development of healthy, livable communities is being increasingly recognized. In urban areas, intersections represent locations where different modes converge, and are often ...

  Citation × Citation Citation Abstract Copy Title: Exploring Pedestrian Responsive Traffic Signal Timing Strategies in Urban Areas Author: Kothuri, Sirisha Murthy Year: 2014 The role of walking in the development of healthy, livable communities is being increasingly recognized. In urban areas, intersections represent locations where different modes converge, and are often viewed as deterrents to walking. This is due to the unwarranted and often unnecessary delays imposed by signal timing policies for pedestrians and increased potential for conflicts. Traditional signal timing design prioritizes vehicles over pedestrians leading to undesirable consequences such as large delays and risky pedestrian behaviors. Pedestrians are accommodated in a manner that is designed to cause least interruption to the flow of motor vehicles. This lack of pedestrian accommodation at signalized intersections is the focus of this dissertation. Understanding pedestrian attitudes and perceptions is important because it offers insights into actual crossing behavior at signalized intersections. An intercept survey of 367 crossing pedestrians was undertaken at four signalized intersections in Portland, Oregon, and binary logistic regression models were constructed to quantify the impacts of demographics, trip characteristics and type of infrastructure on pedestrian perceptions and attitudes regarding delay, crossing time and motivators for crossing decisions. Safety was found to have a larger effect than compliance on the decision to cross the street. Pedestrians at recall intersections expressed higher satisfaction with delay than at actuated intersections. Novel methods to measure pedestrian delay using 2070 signal controllers and Voyage software were developed. These methods have been adopted by the City of Portland to record actuation trends and delays at various intersections. In the absence of demand data, pedestrian push button actuations can be considered as a proxy for crossing demand. The micro-simulation software VISSIM was used to analyze delays resulting from varying pedestrian and vehicle volumes on a network of three intersections in Portland, Oregon. From a pedestrian perspective, free operation was found to be always beneficial due to lower pedestrian delays. However, from a system wide perspective, free operation was found to be beneficial only under low-medium traffic conditions from an overall delay reduction viewpoint, while coordinated operation showed benefits under heavy traffic conditions, irrespective of the volume of pedestrians. Control strategies were developed to identify the best mode of signal controller operation that produced the lowest overall average delay per user. A procedure to identify the optimal control strategy based on user inputs (major street volume to capacity ratios and rate of pedestrian phase serviced for the minor street) was developed. The procedure was applied to a network of three intersections in east Portland, OR and the findings were verified. This research offers significant contributions in the field of pedestrian research. The findings related to attitudes and perceptions of crossing pedestrians offer greater insights into pedestrian crossing behavior and add to the body of existing literature. The methods developed to obtain pedestrian actuations and delay data from signal controllers represent an easy and cost-effective way to characterize pedestrian service at intersections. The results pertaining to signal timing strategies represent an important step towards incorporating pedestrian needs at intersections and demonstrate how control strategies employed to benefit pedestrians could benefit the entire system. Title: Exploring Pedestrian Responsive Traffic Signal Timing Strategies in Urban Areas Author: Kothuri, Sirisha Murthy Year: 2014 The role of walking in the development of healthy, livable communities is being increasingly recognized. In urban areas, intersections represent locations where different modes converge, and are often viewed as deterrents to walking. This is due to the unwarranted and often unnecessary delays imposed by signal timing policies for pedestrians and increased potential for conflicts. Traditional signal timing design prioritizes vehicles over pedestrians leading to undesirable consequences such as large delays and risky pedestrian behaviors. Pedestrians are accommodated in a manner that is designed to cause least interruption to the flow of motor vehicles. This lack of pedestrian accommodation at signalized intersections is the focus of this dissertation. Understanding pedestrian attitudes and perceptions is important because it offers insights into actual crossing behavior at signalized intersections. An intercept survey of 367 crossing pedestrians was undertaken at four signalized intersections in Portland, Oregon, and binary logistic regression models were constructed to quantify the impacts of demographics, trip characteristics and type of infrastructure on pedestrian perceptions and attitudes regarding delay, crossing time and motivators for crossing decisions. Safety was found to have a larger effect than compliance on the decision to cross the street. Pedestrians at recall intersections expressed higher satisfaction with delay than at actuated intersections. Novel methods to measure pedestrian delay using 2070 signal controllers and Voyage software were developed. These methods have been adopted by the City of Portland to record actuation trends and delays at various intersections. In the absence of demand data, pedestrian push button actuations can be considered as a proxy for crossing demand. The micro-simulation software VISSIM was used to analyze delays resulting from varying pedestrian and vehicle volumes on a network of three intersections in Portland, Oregon. From a pedestrian perspective, free operation was found to be always beneficial due to lower pedestrian delays. However, from a system wide perspective, free operation was found to be beneficial only under low-medium traffic conditions from an overall delay reduction viewpoint, while coordinated operation showed benefits under heavy traffic conditions, irrespective of the volume of pedestrians. Control strategies were developed to identify the best mode of signal controller operation that produced the lowest overall average delay per user. A procedure to identify the optimal control strategy based on user inputs (major street volume to capacity ratios and rate of pedestrian phase serviced for the minor street) was developed. The procedure was applied to a network of three intersections in east Portland, OR and the findings were verified. This research offers significant contributions in the field of pedestrian research. The findings related to attitudes and perceptions of crossing pedestrians offer greater insights into pedestrian crossing behavior and add to the body of existing literature. The methods developed to obtain pedestrian actuations and delay data from signal controllers represent an easy and cost-effective way to characterize pedestrian service at intersections. The results pertaining to signal timing strategies represent an important step towards incorporating pedestrian needs at intersections and demonstrate how control strategies employed to benefit pedestrians could benefit the entire system. Close

• 32. [Article] Contextual Influences on Trip Generation

  There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE ...

  Citation × Citation Citation Abstract Copy Title: Contextual Influences on Trip Generation Author: Clifton, Kelly J., Currans, Kristina Marie, Muhs, Christopher D. Year: 2012 There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE rates represent travel behavior for development in single lots and uses, primarily measured in low-density suburban areas. Despite evidence that a more compact urban form, access to transit and a greater mix of uses generates fewer and shorter vehicle trips, local governments are often compelled to use current ITE trip generation rates to evaluate transportation impacts and calculate transportation system development charges (TSDCs). This is due to: a) the expense of collecting local data, b) lack of alternative sources of information, c) the strong industry bias toward using ITE published rates and d) the absence of a empirically tested methodology for adjusting those rates for development occurring in different land use and transportation contexts. Compounding these challenges, cities in Oregon are required to demonstrate that planning and zoning changes will not degrade the performance of state-owned transportation facilities compared to the levels of service documented in the Regional Transportation Plan under the Oregon Transportation Planning Rule, section -0060, and Oregon Highway Plan, Policy 1.F.6. These requirements can conflict with regional policies in Metro's 2040 Growth Concept that call for development of mixed-use centers and corridors to support jobs and freight reliability, a compact urban form and leverage transportation investments such as high capacity transit. Thus, there are gaps in the understanding about how best to evaluate, mitigate and plan for growth under these conditions. This research proposes to develop multi-modal trip generation rates that better reflect the relationship between land use, transportation and travel demand for specific land use types located in various urban settings. The project aims to collect local data (using multi-modal counts and establishment surveys) on a few specific land uses (deemed most problematic to estimate demand and occurring across the spectrum of urban conditions) to develop trip generation rates that are sensitive to demographic, land use and transportation contexts. These new trip rates will be compared to the ITE rates for the same land use category and a methodology for adjusting the ITE rates will be developed. This adjustment methodology will be validated, using additional data collected in this research. The research will be documented and made available to local partners and disseminated widely to reach out to other communities across the country. The research conducted for this project would account for how the built environment (e.g., both land use and transportation) influences travel behavior (number of trips, trip length, mode choice), and determine trip rates that reflect the entire activity spectrum of different development/place typologies. This is extremely important in determining the impact of different development types on the transportation system to: 1) avoid over-planning the system for the surrounding land uses; (2) suggest strategies and investment priorities to encourage more compact, mixed-use areas with more transportation choices and 3) avoid creating regulatory and/or financial barriers to compact form envisioned by local, regional and statewide plans (i.e. uniform TSDCs can result in lower impact development paying the same rates, and thus subsidizing development with higher impact costs to the transportation system). The documentation of the findings and methodology will be applicable to current and future growth and be transferable to other communities, locally and nationally, beyond the Portland region. Title: Contextual Influences on Trip Generation Author: Clifton, Kelly J., Currans, Kristina Marie, Muhs, Christopher D. Year: 2012 There is national interest in building data that expands upon the existing Institute of Transportation Engineers (ITE) trip generation rates to include sites located in a multi-modal context. Current ITE rates represent travel behavior for development in single lots and uses, primarily measured in low-density suburban areas. Despite evidence that a more compact urban form, access to transit and a greater mix of uses generates fewer and shorter vehicle trips, local governments are often compelled to use current ITE trip generation rates to evaluate transportation impacts and calculate transportation system development charges (TSDCs). This is due to: a) the expense of collecting local data, b) lack of alternative sources of information, c) the strong industry bias toward using ITE published rates and d) the absence of a empirically tested methodology for adjusting those rates for development occurring in different land use and transportation contexts. Compounding these challenges, cities in Oregon are required to demonstrate that planning and zoning changes will not degrade the performance of state-owned transportation facilities compared to the levels of service documented in the Regional Transportation Plan under the Oregon Transportation Planning Rule, section -0060, and Oregon Highway Plan, Policy 1.F.6. These requirements can conflict with regional policies in Metro's 2040 Growth Concept that call for development of mixed-use centers and corridors to support jobs and freight reliability, a compact urban form and leverage transportation investments such as high capacity transit. Thus, there are gaps in the understanding about how best to evaluate, mitigate and plan for growth under these conditions. This research proposes to develop multi-modal trip generation rates that better reflect the relationship between land use, transportation and travel demand for specific land use types located in various urban settings. The project aims to collect local data (using multi-modal counts and establishment surveys) on a few specific land uses (deemed most problematic to estimate demand and occurring across the spectrum of urban conditions) to develop trip generation rates that are sensitive to demographic, land use and transportation contexts. These new trip rates will be compared to the ITE rates for the same land use category and a methodology for adjusting the ITE rates will be developed. This adjustment methodology will be validated, using additional data collected in this research. The research will be documented and made available to local partners and disseminated widely to reach out to other communities across the country. The research conducted for this project would account for how the built environment (e.g., both land use and transportation) influences travel behavior (number of trips, trip length, mode choice), and determine trip rates that reflect the entire activity spectrum of different development/place typologies. This is extremely important in determining the impact of different development types on the transportation system to: 1) avoid over-planning the system for the surrounding land uses; (2) suggest strategies and investment priorities to encourage more compact, mixed-use areas with more transportation choices and 3) avoid creating regulatory and/or financial barriers to compact form envisioned by local, regional and statewide plans (i.e. uniform TSDCs can result in lower impact development paying the same rates, and thus subsidizing development with higher impact costs to the transportation system). The documentation of the findings and methodology will be applicable to current and future growth and be transferable to other communities, locally and nationally, beyond the Portland region. Close