Search

Search Results

• 1. [Image] Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine

  	A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was ...
  	Citation × Citation Citation Abstract Copy Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C Close

• 2. [Image] An Experimental Investigation of the Permeability of Kayenta and St. Peter Sandstones to Hypersaline Brine in the Temperature Interval 70 to 90 C at 10. 3-MPa Confining Pressure

  	Permeabilities of 10.2 cm in length, 2.5 cm in diameter Kayenta (porosity, 20.7, +- 1.66%) and St. Peter (porosity, 13.6, +- 0.13%) sandstones to Magmamax No. 1 brine containing suspended solids were determined ...
  	Citation × Citation Citation Abstract Copy Title: An Experimental Investigation of the Permeability of Kayenta and St. Peter Sandstones to Hypersaline Brine in the Temperature Interval 70 to 90 C at 10. 3-MPa Confining Pressure Author: Piwinskii, A.J. Year: 1977 Permeabilities of 10.2 cm in length, 2.5 cm in diameter Kayenta (porosity, 20.7, +- 1.66%) and St. Peter (porosity, 13.6, +- 0.13%) sandstones to Magmamax No. 1 brine containing suspended solids were determined from 70 to 90/sup 0/C at 10.3-MPa confining pressure. Measurements were performed without filters, with one 10-..mu..m filter, and with two 10-..mu..m filters inserted upstream of the core sample. In all cases, there was a dramatic decrease in permeability within the first hour of flow or few hundred pore volumes of flow through the core. Experiments conducted without filters or with one filter yield permeabilities that represent both the rock and the 2- to 3-mm amorphous silica-iron layer on the top face of the core. The experimental results show that if the Salton Sea Geothermal Field (SSGF) were composed of porous, sedimentary formations similar to Kayenta sandstone, long-term injection of unmodified Magmamax brine would not be feasible. In the case of acidified brine, most of the permeability decline may result from the mobilization of calcite Title: An Experimental Investigation of the Permeability of Kayenta and St. Peter Sandstones to Hypersaline Brine in the Temperature Interval 70 to 90 C at 10. 3-MPa Confining Pressure Author: Piwinskii, A.J. Year: 1977 Permeabilities of 10.2 cm in length, 2.5 cm in diameter Kayenta (porosity, 20.7, +- 1.66%) and St. Peter (porosity, 13.6, +- 0.13%) sandstones to Magmamax No. 1 brine containing suspended solids were determined from 70 to 90/sup 0/C at 10.3-MPa confining pressure. Measurements were performed without filters, with one 10-..mu..m filter, and with two 10-..mu..m filters inserted upstream of the core sample. In all cases, there was a dramatic decrease in permeability within the first hour of flow or few hundred pore volumes of flow through the core. Experiments conducted without filters or with one filter yield permeabilities that represent both the rock and the 2- to 3-mm amorphous silica-iron layer on the top face of the core. The experimental results show that if the Salton Sea Geothermal Field (SSGF) were composed of porous, sedimentary formations similar to Kayenta sandstone, long-term injection of unmodified Magmamax brine would not be feasible. In the case of acidified brine, most of the permeability decline may result from the mobilization of calcite Close

• 3. [Image] Geologic Characteristics of a Portion of the Salton Sea Geothermal Field

  	The examination of drill cuttings and core samples from the Magmamax Nos. 2 and 3 and Woolsey No. 1 wells indicate that the sequence of sedimentary rocks in the Salton Sea geothermal field from the surface ...
  	Citation × Citation Citation Abstract Copy Title: Geologic Characteristics of a Portion of the Salton Sea Geothermal Field Author: Tewhey; J.D. Year: 1977 The examination of drill cuttings and core samples from the Magmamax Nos. 2 and 3 and Woolsey No. 1 wells indicate that the sequence of sedimentary rocks in the Salton Sea geothermal field from the surface to below 4000 ft can be divided into three categories Title: Geologic Characteristics of a Portion of the Salton Sea Geothermal Field Author: Tewhey; J.D. Year: 1977 The examination of drill cuttings and core samples from the Magmamax Nos. 2 and 3 and Woolsey No. 1 wells indicate that the sequence of sedimentary rocks in the Salton Sea geothermal field from the surface to below 4000 ft can be divided into three categories Close

• 4. [Image] Viscosity of Brines from the Salton Sea Geothermal Field, Imperial Valley, California

  	The viscosity of chemically analyzed brines from the Salton Sea Geothermal Field was measured from 5 to 90/sup 0/C at 100 kPa. Data indicate that these multicomponent solutions are slightly more viscous ...
  	Citation × Citation Citation Abstract Copy Title: Viscosity of Brines from the Salton Sea Geothermal Field, Imperial Valley, California Author: Piwinskii, A.J. Year: 1977 The viscosity of chemically analyzed brines from the Salton Sea Geothermal Field was measured from 5 to 90/sup 0/C at 100 kPa. Data indicate that these multicomponent solutions are slightly more viscous than a 3.5 molal NaCl solution in this temperature interval Title: Viscosity of Brines from the Salton Sea Geothermal Field, Imperial Valley, California Author: Piwinskii, A.J. Year: 1977 The viscosity of chemically analyzed brines from the Salton Sea Geothermal Field was measured from 5 to 90/sup 0/C at 100 kPa. Data indicate that these multicomponent solutions are slightly more viscous than a 3.5 molal NaCl solution in this temperature interval Close