Search

Search Results

• 1. [Image] Low-Temperature Geothermal Potential of the Ojo Caliente Warm Springs Area, Northern New Mexico

  	A detailed geochemical investigation of 17 waters (thermal and cold, mineralized and dilute) was performed in the Ojo Caliente-La Madera area. Two types of thermomineral waters have separate and distinctive ...
  	Citation × Citation Citation Abstract Copy Title: Low-Temperature Geothermal Potential of the Ojo Caliente Warm Springs Area, Northern New Mexico Author: Vuataz, F.D. Year: 1984 A detailed geochemical investigation of 17 waters (thermal and cold, mineralized and dilute) was performed in the Ojo Caliente-La Madera area. Two types of thermomineral waters have separate and distinctive geologic, geochemical, and geothermal characteristics. The water from Ojo Caliente Resort emerges with temperatures less than or equal to 54/sup 0/C from a Precambrian metarhyolite. Its chemistry, typically Na-HCO/sub 3/, has a total mineralization of 3600 mg/l. Isotopic studies have shown that the thermal water emerges from the springs and a hot well without significant mixing with the cold shallow aquifer of the valley alluvium. However, the cold aquifer adjacent to the resort does contain varying amounts of thermal water that originates from the warm spring system. Geothermometry calculations indicate that the thermal water may be as hot as 85/sup 0/C at depth before its ascent toward surface. Thermodynamic computations on the reaction states of numerous mineral phases suggest that the thermal water will not cause major scaling problems if the hot water is utilized for direct-use geothermal applications. By means of a network of very shallow holes, temperature and electrical conductivity anomalies have been found elsewhere in the valley around Ojo Caliente, and resistivity soundings have confirmed the presence of a plume of thermal water entering the shallow aquifer. The group of lukewarm springs around La Madera, with temperatures less than or equal to 29/sup 0/C, chemical type of NaCaMg-HCO/sub 3/Cl and with a total mineralization less than or equal to 1500 mg/l behaves as a different system without any Apparent relation to the Ojo Caliente system. Its temperature at depth is not believed to exceed 35 to 40/sup 0/C Title: Low-Temperature Geothermal Potential of the Ojo Caliente Warm Springs Area, Northern New Mexico Author: Vuataz, F.D. Year: 1984 A detailed geochemical investigation of 17 waters (thermal and cold, mineralized and dilute) was performed in the Ojo Caliente-La Madera area. Two types of thermomineral waters have separate and distinctive geologic, geochemical, and geothermal characteristics. The water from Ojo Caliente Resort emerges with temperatures less than or equal to 54/sup 0/C from a Precambrian metarhyolite. Its chemistry, typically Na-HCO/sub 3/, has a total mineralization of 3600 mg/l. Isotopic studies have shown that the thermal water emerges from the springs and a hot well without significant mixing with the cold shallow aquifer of the valley alluvium. However, the cold aquifer adjacent to the resort does contain varying amounts of thermal water that originates from the warm spring system. Geothermometry calculations indicate that the thermal water may be as hot as 85/sup 0/C at depth before its ascent toward surface. Thermodynamic computations on the reaction states of numerous mineral phases suggest that the thermal water will not cause major scaling problems if the hot water is utilized for direct-use geothermal applications. By means of a network of very shallow holes, temperature and electrical conductivity anomalies have been found elsewhere in the valley around Ojo Caliente, and resistivity soundings have confirmed the presence of a plume of thermal water entering the shallow aquifer. The group of lukewarm springs around La Madera, with temperatures less than or equal to 29/sup 0/C, chemical type of NaCaMg-HCO/sub 3/Cl and with a total mineralization less than or equal to 1500 mg/l behaves as a different system without any Apparent relation to the Ojo Caliente system. Its temperature at depth is not believed to exceed 35 to 40/sup 0/C Close

• 2. [Image] Dipole-Dipole Resistivity Surveys, Roosevelt Hot Springs KGRA. Final Report, Volume 2

  	Dipole-dipole Resistivity surveys were conducted at Roosevelt Hot Springs KGRA. Three different dipole spacings were used; 99km of traverse line were surveyed with 100m dipoles, 50km with 300m dipoles, ...
  	Citation × Citation Citation Abstract Copy Title: Dipole-Dipole Resistivity Surveys, Roosevelt Hot Springs KGRA. Final Report, Volume 2 Author: Ward, S.H. Year: 1976 Dipole-dipole Resistivity surveys were conducted at Roosevelt Hot Springs KGRA. Three different dipole spacings were used; 99km of traverse line were surveyed with 100m dipoles, 50km with 300m dipoles, and 44km with 1km dipoles. The objectives of the Resistivity surveying were to detect and delineate regions of low Resistivity associated with fracturing, brines, high temperatures, and clay alteration. The Resistivity of rocks that are typical of hydrothermal environments is due to two main conduction mechanisms: (1) electrolytic conduction through pores and fractures; and (2) surface conduction due to a thin zone of cations attracted to those mineral surfaces with net negative charges (especially clay minerals). For saturated rocks, the Resistivity due to electrolytic conduction is a function of the effective porosity of the fractured rock, of the temperature, and of the salinity of the fluid filling the pores and fractures. The Resistivity decreases as the effective porosity, water saturation, salinity, and temperature increase. The presence of clay minerals and pyrite will also decrease the Resistivity Title: Dipole-Dipole Resistivity Surveys, Roosevelt Hot Springs KGRA. Final Report, Volume 2 Author: Ward, S.H. Year: 1976 Dipole-dipole Resistivity surveys were conducted at Roosevelt Hot Springs KGRA. Three different dipole spacings were used; 99km of traverse line were surveyed with 100m dipoles, 50km with 300m dipoles, and 44km with 1km dipoles. The objectives of the Resistivity surveying were to detect and delineate regions of low Resistivity associated with fracturing, brines, high temperatures, and clay alteration. The Resistivity of rocks that are typical of hydrothermal environments is due to two main conduction mechanisms: (1) electrolytic conduction through pores and fractures; and (2) surface conduction due to a thin zone of cations attracted to those mineral surfaces with net negative charges (especially clay minerals). For saturated rocks, the Resistivity due to electrolytic conduction is a function of the effective porosity of the fractured rock, of the temperature, and of the salinity of the fluid filling the pores and fractures. The Resistivity decreases as the effective porosity, water saturation, salinity, and temperature increase. The presence of clay minerals and pyrite will also decrease the Resistivity Close

• 3. [Image] Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976

  	The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance ...
  	Citation × Citation Citation Abstract Copy Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. A regional bipole--dipole electrical resistivity survey was made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. A single hole was drilled to a depth of approximately 300 m (approx. 1000 feet) to obtain a heat flow value that is representative of the area. The data were used to attempt to arrive at a model that unambiguously explains the origin of the thermal springs Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. A regional bipole--dipole electrical resistivity survey was made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. A single hole was drilled to a depth of approximately 300 m (approx. 1000 feet) to obtain a heat flow value that is representative of the area. The data were used to attempt to arrive at a model that unambiguously explains the origin of the thermal springs Close

• 4. [Image] Geothermal Resources, Vicksburg Formation, Texas Gulf Coast

  	The potential for discovering geopressured geothermal reservoirs in the Vicksburg Formation is limited to Hidalgo County along the Lower Texas Gulf Coast. In Hidalgo County, an area of approximately 385 ...
  	Citation × Citation Citation Abstract Copy Title: Geothermal Resources, Vicksburg Formation, Texas Gulf Coast Author: Loucks, R.G. Year: 1978 The potential for discovering geopressured geothermal reservoirs in the Vicksburg Formation is limited to Hidalgo County along the Lower Texas Gulf Coast. In Hidalgo County, an area of approximately 385 square miles (designated the Vicksburg Fairway) contains up to 1,300 feet of geopressured sandstones with fluid temperatures greater than 300/sup 0/F. In-place effective permeability, however, averages less than 1 millidarcy in the Vicksburg sandstones because of fine grain size and extensive late carbonate cementation. Also, areal extent of individual reservoirs is limited in a dip direction by growth faults and in a strike direction by the lenticular morphology of the sandstone bodies. In conclusion, under the present specifications set for a geothermal fairway, the Vicksburg has minimal potential because of low reservoir deliverability, which is constrained by low permeability and somewhat limited reservoir continuity. If future tests indicate that lower permeabilities are acceptable, the Vicksburg Fairway should be reconsidered because of the presence of extremely thick sandstone bodies Title: Geothermal Resources, Vicksburg Formation, Texas Gulf Coast Author: Loucks, R.G. Year: 1978 The potential for discovering geopressured geothermal reservoirs in the Vicksburg Formation is limited to Hidalgo County along the Lower Texas Gulf Coast. In Hidalgo County, an area of approximately 385 square miles (designated the Vicksburg Fairway) contains up to 1,300 feet of geopressured sandstones with fluid temperatures greater than 300/sup 0/F. In-place effective permeability, however, averages less than 1 millidarcy in the Vicksburg sandstones because of fine grain size and extensive late carbonate cementation. Also, areal extent of individual reservoirs is limited in a dip direction by growth faults and in a strike direction by the lenticular morphology of the sandstone bodies. In conclusion, under the present specifications set for a geothermal fairway, the Vicksburg has minimal potential because of low reservoir deliverability, which is constrained by low permeability and somewhat limited reservoir continuity. If future tests indicate that lower permeabilities are acceptable, the Vicksburg Fairway should be reconsidered because of the presence of extremely thick sandstone bodies Close

• 5. [Image] Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976

  	A study was made to determine the origin of the warm springs and to evaluate the geothermal resource potential of the area in the vicinity of the Warm Springs anticline in Bath and Alleghany Counties, ...
  	Citation × Citation Citation Abstract Copy Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 A study was made to determine the origin of the warm springs and to evaluate the geothermal resource potential of the area in the vicinity of the Warm Springs anticline in Bath and Alleghany Counties, Virginia. Phase 1 of the study was the compilation of a geologic map based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. Phase II consisted of a regional bipole-dipole electric resistivity survey made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. Phase III involved the drilling of a single hole to a depth of approximately 300 m to obtain a heat flow value that is representative of the area. The above data were used to arrive at a model that unambiguously explains the origin of thermal springs. It is concluded that the warm springs constitute a geothermal resource for low temperature application such as space heating (LBS) Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 A study was made to determine the origin of the warm springs and to evaluate the geothermal resource potential of the area in the vicinity of the Warm Springs anticline in Bath and Alleghany Counties, Virginia. Phase 1 of the study was the compilation of a geologic map based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. Phase II consisted of a regional bipole-dipole electric resistivity survey made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. Phase III involved the drilling of a single hole to a depth of approximately 300 m to obtain a heat flow value that is representative of the area. The above data were used to arrive at a model that unambiguously explains the origin of thermal springs. It is concluded that the warm springs constitute a geothermal resource for low temperature application such as space heating (LBS) Close