Search

Search Results

• 1. [Image] Geothermal Resource Exploration in Boise, Idaho

  	Exploratory drilling in Boise, Idaho, in the vicinity of the Boise Front Fault has confirmed the presence of a 170/sup 0/F (77/sup 0/C) geothermal resource below about 800 ft (244 m) near the Veterans ...
  	Citation × Citation Citation Abstract Copy Title: Geothermal Resource Exploration in Boise, Idaho Author: Nelson, L.B. Year: 1980 Exploratory drilling in Boise, Idaho, in the vicinity of the Boise Front Fault has confirmed the presence of a 170/sup 0/F (77/sup 0/C) geothermal resource below about 800 ft (244 m) near the Veterans Hospital of the Military Reserve Park. The Idaho National Engineering Laboratory (INEL), sponsored by the Department of Energy, drilled three exploratory slim holes and two deep exploratory test wells. Study results based on tests of the two exploratory-test wells are reported. Faulting related to the Boise Front Fault defines a major physiographic break in the area that acts as a subsurface conduit through which geothermal water circulates. Hydrologic tests indicate that rocks disturbed by the Boise Front Fault may be as much as ten times more permeable than those removed from the major structural lineament Title: Geothermal Resource Exploration in Boise, Idaho Author: Nelson, L.B. Year: 1980 Exploratory drilling in Boise, Idaho, in the vicinity of the Boise Front Fault has confirmed the presence of a 170/sup 0/F (77/sup 0/C) geothermal resource below about 800 ft (244 m) near the Veterans Hospital of the Military Reserve Park. The Idaho National Engineering Laboratory (INEL), sponsored by the Department of Energy, drilled three exploratory slim holes and two deep exploratory test wells. Study results based on tests of the two exploratory-test wells are reported. Faulting related to the Boise Front Fault defines a major physiographic break in the area that acts as a subsurface conduit through which geothermal water circulates. Hydrologic tests indicate that rocks disturbed by the Boise Front Fault may be as much as ten times more permeable than those removed from the major structural lineament Close

• 2. [Image] Stratigraphy and Alteration, 15 Shallow Thermal Gradient Holes, Roosevelt Hot Springs KGRA and Vicinity, Millard and Beaver Counties, Utah

  	Fifteen shallow thermal gradient drill holes were recently completed by Geothermal Power Corporation (GPCR) in the vicinity of the Roosevelt Hot Springs KGRA. Five holes penetrated Tertiary granitic rocks ...
  	Citation × Citation Citation Abstract Copy Title: Stratigraphy and Alteration, 15 Shallow Thermal Gradient Holes, Roosevelt Hot Springs KGRA and Vicinity, Millard and Beaver Counties, Utah Author: Hulen, J.B. Year: 1978 Fifteen shallow thermal gradient drill holes were recently completed by Geothermal Power Corporation (GPCR) in the vicinity of the Roosevelt Hot Springs KGRA. Five holes penetrated Tertiary granitic rocks and Precambrian gneiss east of the KGRA. Seven holes completed entirely in alluvium near the southwestern corner of the KGRA encountered a near-surface marker horizon of Pleistocene pumice and perlite. Maximum calculated alluvial sedimentation rates since initial deposition of this pumice and perlite range from 1 foot in 12,500 years to 1 foot in 2,300 years. Three holes east of the Mineral Mountains penetrated late Cenozoic basaltic andesite beneath a thin veneer of alluvium. All 15 GPCR drill holes appear to be peripheral to a central zone of anomalously high thermal gradient and low resisitivity delineated by previous investigations. GPCR-8 and -14, however, are characterized by high heat flow and relatively abundant manganese oxide mineralization, which may reflect a favorable hydrologic system controlling thermal fluid flow at depth. These holes thus seem most encouraging for discovery of a deeper high-temperature geothermal resource Title: Stratigraphy and Alteration, 15 Shallow Thermal Gradient Holes, Roosevelt Hot Springs KGRA and Vicinity, Millard and Beaver Counties, Utah Author: Hulen, J.B. Year: 1978 Fifteen shallow thermal gradient drill holes were recently completed by Geothermal Power Corporation (GPCR) in the vicinity of the Roosevelt Hot Springs KGRA. Five holes penetrated Tertiary granitic rocks and Precambrian gneiss east of the KGRA. Seven holes completed entirely in alluvium near the southwestern corner of the KGRA encountered a near-surface marker horizon of Pleistocene pumice and perlite. Maximum calculated alluvial sedimentation rates since initial deposition of this pumice and perlite range from 1 foot in 12,500 years to 1 foot in 2,300 years. Three holes east of the Mineral Mountains penetrated late Cenozoic basaltic andesite beneath a thin veneer of alluvium. All 15 GPCR drill holes appear to be peripheral to a central zone of anomalously high thermal gradient and low resisitivity delineated by previous investigations. GPCR-8 and -14, however, are characterized by high heat flow and relatively abundant manganese oxide mineralization, which may reflect a favorable hydrologic system controlling thermal fluid flow at depth. These holes thus seem most encouraging for discovery of a deeper high-temperature geothermal resource Close

• 3. [Image] Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976

  	The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance ...
  	Citation × Citation Citation Abstract Copy Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. A regional bipole--dipole electrical resistivity survey was made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. A single hole was drilled to a depth of approximately 300 m (approx. 1000 feet) to obtain a heat flow value that is representative of the area. The data were used to attempt to arrive at a model that unambiguously explains the origin of the thermal springs Title: Geological and Geophysical Study of the Origin of the Warm Springs in Bath County, Virginia. Final Report, June 1, 1975--April 30, 1976 Author: Costain, J.K. Year: 1976 The results of heat flow determinations and a reconnaissance dipole electrical resistivity survey in Bath County are described. A geologic map was compiled based on published maps and supported by reconnaissance geologic mapping in areas where published maps were not available. A regional bipole--dipole electrical resistivity survey was made in order to detect the presence of resistivity lows that might be associated with a geothermal system at depth. A single hole was drilled to a depth of approximately 300 m (approx. 1000 feet) to obtain a heat flow value that is representative of the area. The data were used to attempt to arrive at a model that unambiguously explains the origin of the thermal springs Close