Oregon Explorer CrossSearch Search Results

Search

You searched for: Start Over Temperature Remove constraint Temperature Subject BRINES Remove constraint Subject: BRINES Subject FLOW RATE Remove constraint Subject: FLOW RATE Material Types Image Remove constraint Material Types: Image

1 - 3 of 3

Search Results

1. [Image] Neutron Formation Temperature Gauge and Neutron Activation Analysis Brine Flow Meter. Final Report, October 1, 1976--March 31, 1978


	Feasibility studies of nuclear techniques applicable to the determination of geothermal formation temperature and two-phase brine flow downhole have been performed. The formation temperature gauging technique ...
	Citation Citation Citation Abstract Copy Title: Neutron Formation Temperature Gauge and Neutron Activation Analysis Brine Flow Meter. Final Report, October 1, 1976--March 31, 1978 Author: Vagelatos, N. Year: 1978 Feasibility studies of nuclear techniques applicable to the determination of geothermal formation temperature and two-phase brine flow downhole have been performed. The formation temperature gauging technique involves injection of fast neutrons into the formation and analysis of the moderated slow neutron energy distribution by appropriately filtered neutron detectors. The scientific feasibility of the method has been demonstrated by analytical computational and experimental evaluation of the system response. A data analysis method has been developed to determine unambiguously the temperature, neutron absorption cross section and neutron moderating power of an arbitrary medium. The initial phase of a program to demonstrate the engineering feasibility of the technique has been performed. A sonde mockup was fabricated and measurements have been performed in a test stand designed to simulate a geothermal well. The results indicate that the formation temperature determined by this method is independent of differences between the temperature in the borehole fluid and the formation, borehole fluid density, and borehole fluid salinity. Estimates of performance specifications for a formation temperature sonde have been made on the basis of information obtained in this study and a conceptual design of a logging system has been developed. The technique for the determination of fluid flow in a well is based on neutron activation analysis of elements present in the brine. An analytical evaluation of the method has been performed. The results warrant further, experimental evaluation Title: Neutron Formation Temperature Gauge and Neutron Activation Analysis Brine Flow Meter. Final Report, October 1, 1976--March 31, 1978 Author: Vagelatos, N. Year: 1978 Feasibility studies of nuclear techniques applicable to the determination of geothermal formation temperature and two-phase brine flow downhole have been performed. The formation temperature gauging technique involves injection of fast neutrons into the formation and analysis of the moderated slow neutron energy distribution by appropriately filtered neutron detectors. The scientific feasibility of the method has been demonstrated by analytical computational and experimental evaluation of the system response. A data analysis method has been developed to determine unambiguously the temperature, neutron absorption cross section and neutron moderating power of an arbitrary medium. The initial phase of a program to demonstrate the engineering feasibility of the technique has been performed. A sonde mockup was fabricated and measurements have been performed in a test stand designed to simulate a geothermal well. The results indicate that the formation temperature determined by this method is independent of differences between the temperature in the borehole fluid and the formation, borehole fluid density, and borehole fluid salinity. Estimates of performance specifications for a formation temperature sonde have been made on the basis of information obtained in this study and a conceptual design of a logging system has been developed. The technique for the determination of fluid flow in a well is based on neutron activation analysis of elements present in the brine. An analytical evaluation of the method has been performed. The results warrant further, experimental evaluation

2. [Image] Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine


	A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was ...
	Citation Citation Citation Abstract Copy Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C

3. [Image] Geothermal Resource and Reservoir Investigations of U. S. Bureau of Reclamation Leaseholds at East Mesa, Imperial Valley, California


	The study included five parts: geology, seismicity, well testing, reservoir simulation, and geochemistry. Included in appendices are: production test data and discussion, interference tests, production ...
	Citation Citation Citation Abstract Copy Title: Geothermal Resource and Reservoir Investigations of U. S. Bureau of Reclamation Leaseholds at East Mesa, Imperial Valley, California Author: Howard, J. Year: 1978 The study included five parts: geology, seismicity, well testing, reservoir simulation, and geochemistry. Included in appendices are: production test data and discussion, interference tests, production tests in the northern portion of the East Mesa KGRA, conversion tables, chemical analysis of fluids from East Mesa wells, and results of laboratory studies of scale samples taken from the vertical tube evaporator. (MHR) Title: Geothermal Resource and Reservoir Investigations of U. S. Bureau of Reclamation Leaseholds at East Mesa, Imperial Valley, California Author: Howard, J. Year: 1978 The study included five parts: geology, seismicity, well testing, reservoir simulation, and geochemistry. Included in appendices are: production test data and discussion, interference tests, production tests in the northern portion of the East Mesa KGRA, conversion tables, chemical analysis of fluids from East Mesa wells, and results of laboratory studies of scale samples taken from the vertical tube evaporator. (MHR)