Search

Search Results

• 1. [Image] Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine

  	A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was ...
  	Citation × Citation Citation Abstract Copy Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C Title: Field Electrochemical Measurements of Corrosion Characteristics of Materials in Hypersaline Geothermal Brine Author: Harrar, J.E. Year: 1977 A flow cell (with appropriate accessories) was developed for use in short-term testing of the corrosion behavior of materials in approximately 100{sup 0}C, hypersaline geothermal brine. The apparatus was designed to accommodate commercial (Petrolite) corrosion measurement equipment and conducted experiments on-line at the Lawrence Livermore Laboratory Test Station in the Salton Sea Geothermal Field. The apparatus also permitted direct readings of corrosion potentials, solution redox potential (E{sub h}), brine flow rate, pH, and temperature. Estimates of general corrosion rates were obtained by the linear polarization resistance technique and from measurements of complete potentiodynamic polarization curves. The latter also afforded predictions of pitting susceptibilities of active-passive type materials. Twenty-two alloys (with various heat treatments) were tested and readily grouped according to general corrosion resistances in acidified hypersaline (approximately 4 M chloride) brine. Especially promising in regard to corrosion resistance-vs-cost is the series of low Cr--Mo steels. Prescaling of materials in unacidified (pH approximately 5.7) brine prior to exposure to acidified (pH 2 to 4.5) brine was found to be beneficial in reducing corrosion rates at 100{sup 0}C Close

• 2. [Image] Geothermal Progress Monitor: Report No. 17, December 1995

  	DOE is particularly concerned with reducing the costs of geothermal power generation, especially with the abundant moderate to low-temperature resources in the US. This concern is reflected in DOE`s support ...
  	Citation × Citation Citation Abstract Copy Title: Geothermal Progress Monitor: Report No. 17, December 1995 Author: Assistant Secretary for Energy and Efficiency and Renewable Energy, Geothermal Division Year: 1995 DOE is particularly concerned with reducing the costs of geothermal power generation, especially with the abundant moderate to low-temperature resources in the US. This concern is reflected in DOE`s support of a number of energy conversion projects. Projects which focus on the costs and performance of binary cycle technology include a commercial demonstration of supersaturated turbine expansions, which earlier Studies have indicated could increase the power produced per pound of fluid. Other binary cycle projects include evaluations of the performance of various working fluid mixtures and the development and testing of advanced heat rejection systems which are desperately needed in water-short geothermal areas. DOE is also investigating the applicability of flash steam technology to low-temperature resources, as an economic alternative to binary cycle systems. A low-cost, low-pressure steam turbine, selected for a grant, will be constructed to utilize fluid discharged from a flash steam plant in Nevada. Another project addresses the efficiency of high-temperature flash plants with a demonstration of the performance of the Biphase turbine which may increase the power output of such installations with no increase in fluid flow. Perhaps the most noteworthy feature of this issue of the GPM, the 17th since its inception in 1980, is the high degree of industry participation in federally-sponsored geothermal research and development. This report describes geothermal development activities Title: Geothermal Progress Monitor: Report No. 17, December 1995 Author: Assistant Secretary for Energy and Efficiency and Renewable Energy, Geothermal Division Year: 1995 DOE is particularly concerned with reducing the costs of geothermal power generation, especially with the abundant moderate to low-temperature resources in the US. This concern is reflected in DOE`s support of a number of energy conversion projects. Projects which focus on the costs and performance of binary cycle technology include a commercial demonstration of supersaturated turbine expansions, which earlier Studies have indicated could increase the power produced per pound of fluid. Other binary cycle projects include evaluations of the performance of various working fluid mixtures and the development and testing of advanced heat rejection systems which are desperately needed in water-short geothermal areas. DOE is also investigating the applicability of flash steam technology to low-temperature resources, as an economic alternative to binary cycle systems. A low-cost, low-pressure steam turbine, selected for a grant, will be constructed to utilize fluid discharged from a flash steam plant in Nevada. Another project addresses the efficiency of high-temperature flash plants with a demonstration of the performance of the Biphase turbine which may increase the power output of such installations with no increase in fluid flow. Perhaps the most noteworthy feature of this issue of the GPM, the 17th since its inception in 1980, is the high degree of industry participation in federally-sponsored geothermal research and development. This report describes geothermal development activities Close