Search

Search Results

• 1. [Article] TMDLS: Statistical Correlations or Mechanistic Modeling?

  In developing TMDL waste-load allocations for the Snake River-Reservoir system in Western Idaho and Eastern Oregon, determinations of the assimilative capacity of the system and the impact of pollutant ...

  Citation × Citation Citation Abstract Copy Title: TMDLS: Statistical Correlations or Mechanistic Modeling? Author: Wells, Scott A., Cole, Thomas M. Year: 2002 In developing TMDL waste-load allocations for the Snake River-Reservoir system in Western Idaho and Eastern Oregon, determinations of the assimilative capacity of the system and the impact of pollutant reduction strategies has been performed using both a statistical-correlation approach and a mechanistic modeling approach. The system included the Lower Snake River, Brownlee Reservoir, Oxbow Reservoir, and Hells Canyon Reservoir with the focus was on Brownlee Reservoir. The statistical approach used on Brownlee Reservoir divided the system into riverine and lacustrine zones. Field data were then averaged over season and location to provide statistical correlations, such as between total phosphorus (TP) and chlorophyll a (chl a), between an anoxic factor (AF) and TP, and between a hypoxic factor (HP) and TP. The anoxic factor is defined as the number of days when dissolved oxygen was less than 2 mg/l and the hypoxic factor was defined as the number of days when dissolved oxygen was less than 6.5 mg/l. The mechanistic approach used a two-dimensional, unsteady, hydrodynamic and water quality model called CE-QUAL-W2. The model was calibrated to field data over a three year period for 1992 (a low flow year), 1995 (an average flow year), and 1997 (a high flow year). Some of the important questions that the TMDL process was to answer included the following. What level of TP is necessary in the river coming into Brownlee Reservoir to reduce the number of days of hypoxia in the reservoir? What are the causes of low-dissolved oxygen in Brownlee Reservoir and what management strategies can be implemented to improve water quality? This paper examines the strengths and weaknesses of answering management questions using these two approaches. Recommendations are suggested for answering assimilative capacity questions that arise in TMDL studies. Title: TMDLS: Statistical Correlations or Mechanistic Modeling? Author: Wells, Scott A., Cole, Thomas M. Year: 2002 In developing TMDL waste-load allocations for the Snake River-Reservoir system in Western Idaho and Eastern Oregon, determinations of the assimilative capacity of the system and the impact of pollutant reduction strategies has been performed using both a statistical-correlation approach and a mechanistic modeling approach. The system included the Lower Snake River, Brownlee Reservoir, Oxbow Reservoir, and Hells Canyon Reservoir with the focus was on Brownlee Reservoir. The statistical approach used on Brownlee Reservoir divided the system into riverine and lacustrine zones. Field data were then averaged over season and location to provide statistical correlations, such as between total phosphorus (TP) and chlorophyll a (chl a), between an anoxic factor (AF) and TP, and between a hypoxic factor (HP) and TP. The anoxic factor is defined as the number of days when dissolved oxygen was less than 2 mg/l and the hypoxic factor was defined as the number of days when dissolved oxygen was less than 6.5 mg/l. The mechanistic approach used a two-dimensional, unsteady, hydrodynamic and water quality model called CE-QUAL-W2. The model was calibrated to field data over a three year period for 1992 (a low flow year), 1995 (an average flow year), and 1997 (a high flow year). Some of the important questions that the TMDL process was to answer included the following. What level of TP is necessary in the river coming into Brownlee Reservoir to reduce the number of days of hypoxia in the reservoir? What are the causes of low-dissolved oxygen in Brownlee Reservoir and what management strategies can be implemented to improve water quality? This paper examines the strengths and weaknesses of answering management questions using these two approaches. Recommendations are suggested for answering assimilative capacity questions that arise in TMDL studies. Close

• 2. [Article] Willamette River Basin Temperature TMDL Model: Model Calibration

  The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all ...

  Citation × Citation Citation Abstract Copy Title: Willamette River Basin Temperature TMDL Model: Model Calibration Author: Berger, Chris, McKillip, Michael Lee, Annear, Robert Leslie, Khan, Sher Jamal, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. The river basin model was originally divided into several reaches. Individual models were developed for each reach. The models were set-up for each section of the Willamette basin as described in Annear et al. (2004a), the models were calibrated to field data and management strategies were evaluated as described in Annear et al (2004b). This report outlines the model calibration of each of these model sections or elements for both the calibration time periods. The calibration period for each model section differs due to the availability of boundary condition data. The model management simulation scenarios (Annear et al, 2004b) also required boundary condition data that extended past the calibration periods. Title: Willamette River Basin Temperature TMDL Model: Model Calibration Author: Berger, Chris, McKillip, Michael Lee, Annear, Robert Leslie, Khan, Sher Jamal, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. The river basin model was originally divided into several reaches. Individual models were developed for each reach. The models were set-up for each section of the Willamette basin as described in Annear et al. (2004a), the models were calibrated to field data and management strategies were evaluated as described in Annear et al (2004b). This report outlines the model calibration of each of these model sections or elements for both the calibration time periods. The calibration period for each model section differs due to the availability of boundary condition data. The model management simulation scenarios (Annear et al, 2004b) also required boundary condition data that extended past the calibration periods. Close

• 3. [Article] Willamette River Basin Temperature TMDL Model: Model Scenarios

  The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all ...

  Citation × Citation Citation Abstract Copy Title: Willamette River Basin Temperature TMDL Model: Model Scenarios Author: Annear, Robert Leslie, McKillip, Michael Lee, Khan, Sher Jamal, Berger, Chris, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. Once the models were set-up for each section of the Willamette basin, the model was calibrated to field data and management strategies were evaluated. These are the subjects of two other reports: Annear et al. (2004) and Berger et al. (2004). This report outlines the results of implementing model scenarios for each of the model sections or elements for specific time periods. The model scenario simulation periods used to investigate management scenarios required boundary condition data that extended past the model calibration periods. The model simulation period for year 2001 was from June 1 to October 31 and for year 2002 from April 1 to October 31. Title: Willamette River Basin Temperature TMDL Model: Model Scenarios Author: Annear, Robert Leslie, McKillip, Michael Lee, Khan, Sher Jamal, Berger, Chris, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. Once the models were set-up for each section of the Willamette basin, the model was calibrated to field data and management strategies were evaluated. These are the subjects of two other reports: Annear et al. (2004) and Berger et al. (2004). This report outlines the results of implementing model scenarios for each of the model sections or elements for specific time periods. The model scenario simulation periods used to investigate management scenarios required boundary condition data that extended past the model calibration periods. The model simulation period for year 2001 was from June 1 to October 31 and for year 2002 from April 1 to October 31. Close

• 4. [Article] Willamette River Basin Temperature TMDL Model: Boundary Conditions and Model Setup

  The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all ...

  Citation × Citation Citation Abstract Copy Title: Willamette River Basin Temperature TMDL Model: Boundary Conditions and Model Setup Author: Annear, Robert Leslie, McKillip, Michael Lee, Khan, Sher Jamal, Berger, Chris, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. Once the models were set-up for each section of the Willamette basin, the model was calibrated to field data and management strategies were evaluated. These are the subjects of two other reports: Annear et al. (2004b) and Berger et al. (2004). This report outlines the model development of each of these model sections or elements for both the calibration time periods and the management scenario time periods. The calibration period for each model section differs due to the availability of boundary condition data. The model simulation periods used to investigate management scenarios (Annear et al, 2004b) also required boundary condition data that extended past the calibration periods. Title: Willamette River Basin Temperature TMDL Model: Boundary Conditions and Model Setup Author: Annear, Robert Leslie, McKillip, Michael Lee, Khan, Sher Jamal, Berger, Chris, Wells, Scott A. Year: 2004 The State of Oregon Department of Environmental Quality (DEQ) is developing a TMDL for temperature in the Willamette River basin shown in Figure 1. The study area included the Willamette River and all major tributaries (except the Tualatin River where a TMDL process was already concluded). A large section of the Columbia River was also modeled to provide adequate boundary representation of tidal flows in the lower Willamette River. The Willamette River below the Oregon City Falls in the Portland metropolitan area has a typical diurnal tidal range of 1 m. The development of a dynamic model of temperature and hydrodynamics of the entire river basin incorporating shading were primary requirements of this modeling study. The model would be used by DEQ to set temperature limits on point source dischargers and to evaluate the impact of management strategies on river temperatures to improve fish habitat. Some of these strategies included modifications of the dam at the Willamette River Falls south of Portland and channel reconfigurations. Once the models were set-up for each section of the Willamette basin, the model was calibrated to field data and management strategies were evaluated. These are the subjects of two other reports: Annear et al. (2004b) and Berger et al. (2004). This report outlines the model development of each of these model sections or elements for both the calibration time periods and the management scenario time periods. The calibration period for each model section differs due to the availability of boundary condition data. The model simulation periods used to investigate management scenarios (Annear et al, 2004b) also required boundary condition data that extended past the calibration periods. Close